Why Does the Conveyor Belt Slip on the Drive Pulley?

Nov 07, 2026|

Why Does the Conveyor Belt Slip on the Drive Pulley?

 

Tell Slipping Apart from Other Faults
Slipping means the pulley keeps turning while the belt stalls or runs visibly slower, usually with squealing, a hot shell and a burning smell. It is not the same as belt misalignment or a stalled motor, and each needs a different diagnosis.

info-1024-576

Six Root Causes

1.Insufficient tension---The belt stretches naturally after operation; the tension stroke is not adjusted, reducing effective friction force.
2.Loss of friction---Lagging wear, oil/water film on roller surface or dust ingress. This is the most common and easily overlooked cause.
3.Overload /weak starting torque---Instantaneous load exceeds design value, or motor power is selected based on average load instead of peak load.
4.Insufficient wrap angle---Single-drum drive or poorly positioned bend pulley leads to actual wrap angle below 180°.
5.Mismatched diameter and belt speed---Small roller diameter results in insufficient contact area.
6.Pulley not rotating---Failed key connection, seized bearing or damaged internal gear. It appears to slip, but it is actually drive failure.

Troubleshoot from Cheapest to Most Expensive
Clean the roller surface and re-tension the unit first → then measure wrap angle and tension → next verify load and motor power → finally disassemble and inspect the roller interior.
Important note: Continuously increasing belt tension to suppress slipping will accelerate bearing and oil seal damage.

Permanent Fixes
Renew worn lagging (ceramic or grooved lagging for heavy-duty applications);
add a snub pulley to increase wrap angle;
recheck drum motor power against peak torque;
install a belt slip switch for alarm and shutdown, avoiding operation under faulty conditions.

← Previous: No Information
Send Inquiry